logo

Knowledge

Contact Us

share

Technological points and process measures of titanium tube welding

Oct 05, 2016

1. Welding protection measures

Because of the poor thermal conductivity of titanium material, the weld pool diameter is larger, so in order to increase the welding pool protection area, the welding torch nozzle should be appropriately increased, generally more than 16mm nozzle should be appropriate. Welding protection is the biggest problem of titanium tube welding. In the welding process, in order to protect the high temperature zone above 400 degrees, usually add a drag cover on the welding torch to achieve, some data also provides a lot of methods. For the protection of pipeline welding cover design is the technical specification of pipe making complete way, obviously, this is not much in the specification of pipe can be used, but when the specifications, high cost, and complicated installation is inconvenient in the construction of intermediate frequency. After several experiments, the author has designed a low cost and easy to operate local protective cover, which effectively solves the difficult problem of field welding protection of titanium pipe.


2. Prevention of welding porosity

Because the welding porosity is mainly caused by the contamination of the groove surface, so in order to prevent welding holes, in addition to the use of the clean gas with low Ar content protection, the key is to press the impurity cleaning procedure strictly on the groove surface of the groove, after pasting medical white tape sealing protection, avoid groove contaminated again.


3. Control of welding line energy

The relevant foreign standards are required to ensure the fusion of the premise, as far as possible to use small line energy welding, information is generally in the 7 ~ 35kJ / cm. Considering that the heat dissipation rate is slow, it needs argon to cool down rapidly after welding, so the welding line energy should be selected at lower value. It is advisable to adopt small current and slow welding in construction.


4. Inter layer temperature control

The higher the temperature between the layers is, the higher the residence time of the weld and HAZ zone is, the slower the cooling rate is, thus increasing the grain size at room temperature. The interlayer temperature should be controlled below 200 centigrade.


5. Argon flow rate and ventilation time

The argon flow rate of the nozzle shall be 12~15 L/ min according to the conventional conditions. The flow rate of the protective hood and the protective gas on the back shall be no less than 25 L/ min. Before welding shall be in the back by argon gas (general in 15 ~ 60 s), the volume should not be less than 6 times more than the volume of reserve back cavity, so that the air full replacement of AR and back, at the same time to protect the surface after arcing at the arc welding temperature, should be in 300 C (time in 15 ~ 60 s, according to the diameter of ascending gradually extended) to stop after the air protection.

Related Industry Knowledge
Product Catalog
Medical Titanium
Industrial Titanium
Leisure Life Titanium 
Titanium Bolts & Screws
Product Catalog
Titanium Flange
Titanium Fittings
Sputtering Target
Non-Ferrous Metal
Quick Navigation
About Us

Products
News
Exhibition
Contact information

710065,5th Keji Road,Gaoxin District,Shaanxi, 710065, China.

Tel: 86-029-87547434

Tel: 86-18691573651

info@tsm-titanium.com

Copyright © TSM Technology Co.,Ltd All Rights Reserved.